Self test 9.1

To estimate whether the analyte can be said to be present in the sample at the level of LoD of the analysis method 

To compare two analytical methods using LoD estimates found from literature. The LoD values have been estimated with different approaches. 

To interpret whether an analyte is present in the sample or not 

Sampling method  

Matrix effects caused by the sample

The electrical noise caused by the instrument

Recovery of the analyte from the sample in sample preparation step

Drift of the instrument signal in time 

A metabolite of a drug cannot be detected with a screening test from the saliva of a criminal – the drug has therefore not been used with 100% certainty 

Melamine in milk powder is measured. The LoD value of the used analysis method is 1 mg/kg. The results show the content of 0.2 mg/kg and therefore this number should be reported as the result. 

The pesticide imazalil was measured from an orange. The analyte was detected however the result is under the allowed MRL value. Therefore the analyte can be said to be present but in an allowed concentration. 

LoD is a characteristic that shows the capability of the used instrument (detector) to give information whether the analyte is present or not in any matrix 

LoD is an estimated value that shows the limit where we can reliably say whether the analyte can be identified in the matrix with the particular analysis method 

LoD is the value that shows if the analyte is present or not in the sample

LoD is the true value below which the analysis method can never state the presence of the analyte 

The lowest concentration level of the calibration line 

The lowest concentration under which quantification of the result is impossible

The level at which it is possible to quantify the result with accuracy that is fit for purpose

A level at least 10 times higher than LoD